Hasnt happened in a wile but the service 4x4, abs, ebs lights came on todayi was able to get this code
U0415- implausible data received from abs.
Any ideas what the problem is or how to correct it?
Hasnt happened in a wile but the service 4x4, abs, ebs lights came on todayi was able to get this code
U0415- implausible data received from abs.
Any ideas what the problem is or how to correct it?
JBA
4XG
S4XC
BAD WIRE FROM TPS SIGNAL WIRE TO ECM/PCM
An Implausible Data Configuration can be caused when the PCM / TCM / FCM are not talking to each other
the "U" codes are only a communication error and won't affect performance or pull timing.
U140E-IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVED
When Monitored: Continuously with the ignition on.
Set Condition: When the Anti-Lock Brake Module detects an incorrect CAN messages from the Engine Control Module (ECM).
Possible Causes
FCM CAN BUS DTCS
ENGINE DTCS
ANTI-LOCK BRAKE MODULE
this DTC is generated by the ABS control module and should not illuminate the engine MIL. it may, however, illuminate the ABS warning lamp. the ABS module does not recognize a message from the PCM. pretty sure your B&G PCM is causing this. not the first one i've read about.
Hope this helps........
Is it a hard code? Meaning if you erase it, does it immediately come back on?
I just sat down too damnit. Let me relax for about 45 minutes and then i'll get up to check my manual... that will at least point you in the direction of which sensor is sending the bad signal.
Edit: nevermind... thanks for letting me be lazy don! (right? cico = don? i can't remember...)
Electrical Diagnostics
try this....
From another Forum
Last edited by cico7; 12-09-2011 at 03:04 PM.
Thanks! Thays helps alot. You think it could be sending a bad signal due to my swim the other day?
JBA
4XG
S4XC
Yea thays whar i was figuring.
Matt- i cleared the code and ut came back but not instantly. Prob around 30 min later
JBA
4XG
S4XC
I'd take a good look at the modules... anything that looks like it got wet/submerged, disconnect, dry off terminals, use some contact cleaner, some dielectric grease, plug back in and keep fingers crossed (dico the battery first..)
Will do. Need to get it right b4 the trip
JBA
4XG
S4XC
There are currently 1 users browsing this thread. (0 members and 1 guests)