Wallaaaaaa - After everything has been removed - This is how your WK should like (and how your XK might look). We are ready to begin installing stuffs.. yayyyy rawrrrrr!!


Pull these brackets out of the bag, get them ready... they are next!


Place these brackets LIKE SO... so that they fit... Just like a puzzle!! yeeaaahhhhh.

Passenger side


Driver side


Retreive your first piece of 4xG mounting parts and install! (Part numbers XG-K200.01 and XG-K200.02) Pictured BELOW!
It will be bolted to the mounting brackets you just placed inside the cross member. Use the nuts you PURCHASED, and hand tighten this part to the bracket. (4xG stresses that you do NOT fully tighten... so I stress you just hand tighten.)

Passenger Side - follow this procedure for both sides


Please pay close attention to how these backing plates are placed inside the cross member. There are two squares on each of these brackets.. you want the side of this bracket with the GREATEST distance between the squares facing OUTWARD. Match these up with the holes that go through the frame. Line everything up because we will be installing the inside mounting brackets next!


Get your inside mounting brackets - part numbers XG-K200.03 and XG-K200.04) using two 1.25” x 7/16” hex bolts and install them.. Place bolts in the holes and screw them in, with your other hand hold the inside back plate in place and also hold the nut over the hold while you twist the bolts in. Picture below! (In this picture I used the wrong screws - I did fix this, but don't make my mistake, I had to go back)