More numbers LOL I should say my normal route that gave me 18MPG today is mostly 60MPH kinda hilly not flat by any means but I only had 2 stop lights hit them both and 2 stop signs. So that's four 0-60 starts for me and I take my time doing it to LOL now today I went home a different route lots of stop lights speeds were fro
45-55 MPH the hole way. I did get caught by several lights but still got 16MPG oh and I mounted the programmer
Sent from my iPhone using Tapatalk
Last edited by Sal-XK; 02-21-2012 at 12:31 PM.
Nice ive been thinking of using a cell phons holder to mount mine on that side too. But a
Thinking of getting a new programmer.
Do you leave yours plugged in all the time?
JBA
4XG
S4XC
Right now I am leaving it plugged in it powers down after a few minuets once you shut the jeep off then just hit any button and it pops back on. I had gift card from the holidays still so went to bestbuy and picked that one up for $26 it was the only they had in there to.
Added the LED tail lights to the rear bumper. Putting these in the XK is simple and straight forward no issues and pretty easy. Putting these in the WK is a giant PITA to say the least. The WK has some support pieces in the way behind the bumper that needed to be ground a way.
Pretty much straight forward just measure and cut. I recommend cutting slightly smaller and testing fitting and continue until you get a good tight fit.
Wiring is pretty straight forward you have a couple of options I guess I just tapped into tow package in back. For AJ I tapped in and extended his 4 prong trailer plug because he uses his. On mine I use the 7 prong so the 4 was just hanging behind my tow package so I just cut and tapped into that and all done.
Looks good man and I'm sure it adds to the safety factor for other drivers. It matches your color scheme too.
SOLD - 2005 | WK | Khaki | 3.7 | QT1 | OME HD Front Struts | Rusty's 2" lift in Rear w/ Monroe load levelers (F150 version) | 265/70 Nitto Terra Grapplers | 17" Moabs | 1.5" wheel spacers | Pinch weld mod | Rear fender trim mod | 4xG Matrix w/ reciever hitch | 4xG Belly guard | SOLID Diff cover | Cobra CB radio | 4xG CB radio antenna mount
I would like to do something like that, but instead of brake lights make more powerful reverse lights.... hmmm....
Where'd you the the lights from?
I'd probably throw a little pushbutton switch on the shifter that way i could control the reverse lights separately, but make it somewhat intuitive while im shifting in/out of reverse. This will have to be my next mod. It'll really come in hand for my OBX trip this summer too.
There are currently 5 users browsing this thread. (0 members and 5 guests)