I added Monroe Load Levelers in the back to bring it up an inch to 37 1/2. I had also planned on adding Matt's spacer, but there is a problem......... it barely squeaks through the garage now.....

What does that black triangular bubble that sticks up on the back center of the roof do? And can I remove it before the garage does? It might make a mess when it does it.

Also, I might be higher in the front due to not cranking the strut bolt all the way down on the spring until it bottomed out. What are the implications of this? maybe it is causing clunking in the front end when going over bumps and additional height (who wants that!)

Also what is the best way to tighten that nut once the struts are in place? I used tin shears to increase access through the fender tower but the shaft spins with the nut. If i grab it from below with vise grips it may mark up the shaft and create leaks in the seal, no??????