This weekend I made some progress but not as much as Iwould have liked.

Saturday:
After removing the struts, control arms and knuckle on both sides, a buddy andI took the control arms over to his house to remove the bushings. A couplehours with his cutting torch and a big hammer we were able to get all 3bushings out of each LCA. We made a mess out of his garage floor and part ofhis driveway with all of the burnt rubber. We also removed the ball joints from both the upper and lower CA's.





We also took the struts assembly apart and then assembled the old springs onthe new OME struts and mounts.




Then it was time to take our families out to to an Irish pub for dinner andcelebrate St Paddy's Day.


Today we pressed in the new bushings and the ball joints on the LCA. We couldn't get the upper ball joints in the CA's. After about an hour I decided I would just take them up to a local shop to have them do it on their press sometime later this week.