I think im gonna have to stop driving myself crazy and try taking a more qualitative approach..... then cut some damn springs and install them and see what happens

OME MD = 14.56" free height
OE Spring= 13.25" free height (1.31" less than OME)

Cut OME MD spring rate > OME MD spring rate (530) > stock spring rate ... so regardless of what it ends up being, its a heavier rate than stock.

I'll double check the measurements when I have the springs here, but if 1/2 coil cut off the OME MD gives a 13.75" free height, that's 1/2" over stock which should yield ~3" lift with the 5100s on the highest setting, not including additional lift from the increased spring rate.

So there it is, i've convinced myself to cut 1/2 coil again. Lets see if it sticks this time lol