Slightly bigger bit then whatever your trying to drill out. I thought people were cutting the cross member out?
Slightly bigger bit then whatever your trying to drill out. I thought people were cutting the cross member out?
Drilling is much cleaner but it does take some work as you have to step up the drill bits unless you have one of the ones with many different sizes all-in-one.
2006 XK Limited, 5.7L Hemi
Dark Khaki, QDII, Rocky Road 2.25" lift, Steel Armadillo front bumper with Warn PowerPlant winch, Steel Armadillo rear bumper w/ tire carrier, Rock Sliders, Light Bar & Front Fender Tube Fenders, 4xGuard belly skid plate & rear differential guard, BFG M/T A/T 255/75R17s on Rubicon rims, Spidertrax 1.5 inch wheel spacers, Rhino Rack Pioneer Tray with FoxWing Awning, Superchips VIVID Programmer, Air Flow snorkel, Steel Armadillo Secure Console, Cobra CB Radio, Lock Pick Video Programmer, ASFIR Skid Plates.
Knappster's Garage
AKA: the Owner of The Steel Armadillo L.L.C.
They were a bit pita did you reuse the holes on the bottom or drill new ones ?
2010 5.7 QTII - OME HD w/ 3/8" spacers up front and F150 MLL in rear, JBA UCA 6.7, JKS 2034 Front Quick Disconnects, Gas Tank Skid Mod, PinchWeld Mod, 1.5" SpiderTrax, General Grabber AT 265/70/17, Custom Front Receiver / Plow Mount, Custom Tow Rings F/R, Diablo Intune.
Here is a direct link to the post:
http://www.jeepcommander.com/forums/...1&postcount=16
2010 5.7 QTII - OME HD w/ 3/8" spacers up front and F150 MLL in rear, JBA UCA 6.7, JKS 2034 Front Quick Disconnects, Gas Tank Skid Mod, PinchWeld Mod, 1.5" SpiderTrax, General Grabber AT 265/70/17, Custom Front Receiver / Plow Mount, Custom Tow Rings F/R, Diablo Intune.
There are currently 1 users browsing this thread. (0 members and 1 guests)