Tell me what you guys think

[Sal-XK]

The same for the rockers. Just make sure you get them scuffed up good. The pros sand the paint with like 220 grit or even 180 grit paper. That is way too rough to do a traditional paint job which would be like 500 grit or finer but the bed liner will cover those rougher scratches up easily. If you can get access to a compressor and a D.A. sander that would be the way to do it.

Ok sounds like a plan then. I think I will add this to my winter mod list unless I get bored LOL.

[IamJEEP]

Sal, that looks good. Just make sure to mask up all the door jams well so no overspray gets in there. Maybe while you're at it, you can shave the side moldings!

[Sal-XK]

I'm assuming by shave you mean remove the side moldings? I'm still thinking about that not sure what to do there.

[IamJEEP]

Yes, that is what I meant.

[Sal-XK]

I was looking at it but not sure what to do. On one hand the plastic trim does provide a little extra protection as well. I really need to get rid of the running boards so I can see what that looks like but there actually providing me a ton of protection right now and I can't afford rock rails anytime soon.

[NeilSmith]

I haven't seen one without the side moldings. Are there holes under there like the Grand Cherokee has ? They do provide some protection against door dings, that is the primary reason they are on there to begin with.

[IamJEEP]

I believe they are mounted the same as the cherokee, but I dont know for sure.

I agree that it would be smarter to keep them (moldings) in place for protection, but the "Cool" factor would rise up if they were shaved. I have no plans of paint/body work in the near future or else I would of done it to mine.