Results 1 to 10 of 91

Thread: Chrysler Recalls Almost 470,000 Jeep SUVs

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Lifetime Member Getting Dirty 1USMC's Avatar
    Join Date
    Dec 2010
    Location
    South Texas
    Posts
    371
    Rep Power
    14
    ..

    OMG !!! The casualties continue to mount !! Will it ever END ???

    Looks like the "fix" was to late for this poor owner who remote started his XK and then it rolled slowly out his driveway...... ;-)




  2. #2
    Lifetime Member Getting Dirty TrialByFire's Avatar
    Join Date
    Mar 2011
    Location
    Albuquerque, NM
    Posts
    356
    Rep Power
    14
    Quote Originally Posted by 1USMC View Post
    ..

    OMG !!! The casualties continue to mount !! Will it ever END ???

    Looks like the "fix" was to late for this poor owner who remote started his XK and then it rolled slowly out his driveway...... ;-)



    Wow! Jaws of Life couldn't have uncanned that poor soul!

    I'm still confused about this recall. I thought it was the transmission that shifts on its own but the notice says its the NV245 transfer case. The TC does have a Neutral position for towing and is electrically actuated so I guess that there is no way the 'cracks' could cause it to shift into Drive.

  3. #3
    Lifetime Member Getting Dirty 1USMC's Avatar
    Join Date
    Dec 2010
    Location
    South Texas
    Posts
    371
    Rep Power
    14
    .
    “ …experience a transfer case actuator encoder electrical failure that results in unintentional transfer case shifting into or through the neutral position, which may result in vehicle rollaway…"


    Ok, so the way I was seeing this as our transfer cases have 3 “positions” Hi, Low and Neutral.

    For me to select neutral I have to :

    1. Key ON, engine off.
    2. Vehicle stopped, with foot on brake.
    3. Place the transmission into NEUTRAL.
    4. Hold down the NEUTRAL “pin” switch (with a pen,
    etc.) for four seconds until the LED light by the switch
    starts to blink indicating shift in progress. The light will
    stop blinking (stay on solid) when the NEUTRAL shift is
    complete.A“4WD SYSTEM IN NEUTRAL” message will display

    “ This range disengages both the front and rear driveshafts
    from the powertrain. “

    The way I understood it, the “crack”, bypassed all the steps we have to perform to get the transfer case into neutral.

    Is that the way you see it ???
    Last edited by 1USMC; 05-15-2013 at 05:10 PM.

  4. #4
    Lifetime Member Getting Dirty pjmjr508's Avatar
    Join Date
    Jan 2011
    Location
    Everett WA
    Posts
    1,673
    Rep Power
    15
    basicly that is how I see it. I am guessing that mode is there for a flat tow.
    PJMJR508
    (Happy Jeep)

  5. #5
    Lifetime Member Getting Dirty 1USMC's Avatar
    Join Date
    Dec 2010
    Location
    South Texas
    Posts
    371
    Rep Power
    14
    Quote Originally Posted by pjmjr508 View Post
    basically that is how I see it. I am guessing that mode is there for a flat tow.
    Yes , I remember the " flat tow " capability in case of emergency advertised.

    But Wow... it can be mind boggling to think that perhaps one stray intermittent " tron " could do all the electronic and mechanical things the operator has to do to get the same result ( if thats whats going on ).
    Last edited by 1USMC; 05-15-2013 at 08:50 PM.

  6. #6
    Lifetime Member Getting Dirty 1USMC's Avatar
    Join Date
    Dec 2010
    Location
    South Texas
    Posts
    371
    Rep Power
    14
    .


    Got mine today >>



  7. #7
    Administrator
    Join Date
    Sep 2019
    Posts
    1
    Blog Entries
    36
    Rep Power
    10
    Received mine in the mail today as well.
    2006 XK Limited, 5.7L Hemi
    Dark Khaki, QDII, Rocky Road 2.25" lift, Steel Armadillo front bumper with Warn PowerPlant winch, Steel Armadillo rear bumper w/ tire carrier, Rock Sliders, Light Bar & Front Fender Tube Fenders, 4xGuard belly skid plate & rear differential guard, BFG M/T A/T 255/75R17s on Rubicon rims, Spidertrax 1.5 inch wheel spacers, Rhino Rack Pioneer Tray with FoxWing Awning, Superchips VIVID Programmer, Air Flow snorkel, Steel Armadillo Secure Console, Cobra CB Radio, Lock Pick Video Programmer, ASFIR Skid Plates.

    Knappster's Garage


    Profile for Knappsters

    AKA: the Owner of The Steel Armadillo L.L.C.

Thread Information

Users Browsing this Thread

There are currently 4 users browsing this thread. (0 members and 4 guests)

Similar Threads

  1. Why can't Chrysler build a decent front end anymore?!?!?
    By The_War_Wagon in forum Suspension & Lifts
    Replies: 7
    Last Post: 12-11-2012, 08:25 PM
  2. It's still a Chrysler product (New addition to my stable)
    By Adondo in forum Picture / Media Posts
    Replies: 10
    Last Post: 11-29-2012, 11:48 AM
  3. Anyone hear about the 2012 V6 Chrysler engine?
    By superacerc in forum General "Non-Jeep" Discussions
    Replies: 9
    Last Post: 09-26-2011, 12:41 PM
  4. Jeep Commander Rear Diff disassembly Chrysler 8.25 29 spline 12 bolt QD2
    By Sal-XK in forum Transmissions / Transfer Cases / Drive Train
    Replies: 0
    Last Post: 03-25-2011, 06:45 PM
  5. Jeep Commander Rear Diff disassembly Chrysler 8.25 29 spline 10 bolt QT2, QT1
    By Sal-XK in forum Transmissions / Transfer Cases / Drive Train
    Replies: 0
    Last Post: 02-10-2011, 03:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •